KNX programming in ETS for contractors

KNXexpert / KNX programming

KNX programming in ETS for contractors

I program KNX installations in ETS 6 for electrical contractors, integrators and design offices across Poland. I take on part of the project or all of it — from the group address structure to scenes and logic — and you get a working installation and a documented project file.

Ask for a programming quote
ETS 6Certified KNX integrator18 years of KNX experience

Programming scope

Project structure

Topology, physical addresses and a clear group address structure following a fixed naming convention — so the project can still be read and extended years later.

Lighting and shading

Switching, dimming, scenes, roller blind and venetian control, sun and wind automation.

Heating and cooling

Zone control, operating modes, integration with heat pumps, ventilation and air conditioning via gateways.

Logic and schedules

Logic functions, leaving-home scenarios, time schedules, interlocks and priorities.

Visualisation

Preparing addresses and objects for a touch panel, visualisation server or mobile app.

What I need to start

01

Design or device list

The list of devices and their locations. If there is no design, we define the scope from the floor plans and the distribution board.

02

Function description

What should work in which rooms — a table or notes from the client meeting are enough.

03

Access to the installation

For download and testing: remotely via an IP interface or on site.

What you get

ETS project file

A complete project with described group addresses and device parameters.

Functions and scenes

A list of what the installation does — to hand over to the client at acceptance.

As-built documentation

Device schedule, topology and the information needed for future service.

I hand over the project file in full. The installation does not depend on me — any KNX integrator can service and extend it.

Frequently asked questions

Do you program remotely?

Yes. The programming itself is done remotely; download and testing are done remotely via an IP interface or on site, depending on the installation.

Can I outsource only part of the project?

Yes. I can program, for example, just the heating or the logic and scenes, and leave the rest to your team. I work per project, with no exclusivity agreements.

How much does KNX programming cost?

It depends on the number of devices and the complexity of the logic. I give a specific quote and date once I receive the device list or the design.

Tell me about your project

Send the scope of work or the device list — I will get back to you with a quote and a proposed date.

Go to the form

or directly: kontakt@elnext.pl · +48 530 283 277