On-site KNX commissioning
Program download, functional testing and handover. I come to the site, check every circuit, fix issues on the spot and hand over a working installation — to your team or directly to the client.
Ask for a commissioning dateHow commissioning works
Bus and power check
Line voltage, bus continuity, power supplies and couplers — before anything is downloaded.
Physical addresses and download
Assigning addresses to the devices and downloading the program from the ETS project.
Functional testing
Room by room: every lighting circuit, every blind, every heating zone, every button.
On-the-spot corrections
Swapped circuits, reversed blind directions, missing functions — fixed straight away, not at the next visit.
Training and handover
I show the team or the client how the installation works and hand over the as-built documentation.
What usually comes up during commissioning
Swapped circuits
The bedroom cable ended up on the channel assigned to the bathroom. It is fixed in the board or in the project — what matters is that the documentation matches reality.
Bus faults
Reversed polarity, a break in the cable, a line that is too long without a repeater.
Deviations from the design
A different device than in the schedule, a missing sensor, changes made on site without updating the documentation.
Frequently asked questions
Will you commission an installation programmed by someone else?
Yes, if the ETS project file is available. If it is not, we start by taking over the installation — described on a separate page.
Where do you travel?
Anywhere in Poland. Travel cost depends on the distance and is included in the quote.
Do you also do the programming?
Yes — I can prepare the program and commission it, or commission a program prepared by your company.
Let’s schedule commissioning
Tell me where the site is, how many devices the installation has and when you need the handover.
Go to the formor directly: kontakt@elnext.pl · +48 530 283 277